Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chevrolet Corvette V8-6.2L SCFACTORY OEM SERVICE PROCEDURE
Door Lock Control Module Replacement
Door Lock Control Module Replacement
Removal Procedure
1. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement - Left Side (Front Side Door Trim Panel Replacement - Left Side).
Important: The door control module is part of the power window regulator and is serviced as an assembly.
2. Remove the window regulator. Refer to Door Window Regulator Replacement (Door Window Regulator Replacement).
Installation Procedure
1. Install the window regulator to the door. Refer to Door Window Regulator Replacement (Door Window Regulator Replacement).
2. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement - Left Side (Front Side Door Trim Panel Replacement - Left Side).
3. Refer to Control Module References (Programming and Relearning) for programming and setup information.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.