Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chevrolet Corvette V8-6.2L SCFACTORY OEM SERVICE PROCEDURE
Brake System Components
Front of Vehicle/Engine Compartment Component Views
Brake System Components
1 - Brake Pressure Modulator Valve (BPMV)
2 - Brake Fluid Level Switch
3 - Electronic Brake Control Module (EBCM)
4 - Steering Angle Sensor
5 - Brake Pedal Position (BPP) Sensor
6 - Yaw and Lateral Accelerometer Sensor
7 - Park Brake Switch
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.