Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chevrolet Corvette V8-6.2L SCFACTORY OEM SERVICE PROCEDURE
Power Seat Control Module: Locations
Passenger Compartment/Roof Component Views
Driver Seat Components
1 - Inflatable Restraint Seat Position Sensor - Driver
2 - Seat Rear Vertical Motor - Driver
3 - Seat Rear Vertical Motor Position Sensor - Driver (AAB)
4 - Seat Front Vertical Motor - Driver (AAB)
5 - Seat Front Vertical Motor Position Sensor - Driver (AAB)
6 - Memory Seat Module - Driver (AAB)
7 - Heated Seat Control Module - Driver (KA1)
8 - Seat Horizontal Motor Position Sensor - Driver (AAB)
9 - Seat Horizontal Motor - Driver
10 - Inflatable Restraint Side Impact Module - Left
11 - Seat Lumbar Adjuster Switch - Driver
12 - Seat Adjuster Switch - Driver
13 - Seat Belt Pretensioner - Driver
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.