WARNING: This page is about a different car, the 2010 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Replacement or reprogramming of the ECM, or replacement of the clutch pedal position sensor (CPPS) or clutch pedal requires that a CPPS learn procedure be performed. Failure to perform the CPPS learn procedure may result in personal injury or damage to the vehicle or its components if the vehicle is in gear and the starter motor is accidentally engaged.

If the engine control module (ECM) is replaced, the following procedures must be performed:

The ECM Reprogramming-Refer to Service Programming System (SPS) .
The Theft Deterrent Programming-Refer to Immobilizer System Component Programming .
The CKP Variation Learn-Refer to Crankshaft Position System Variation Learn .
The Clutch Pedal Position Sensor Learn-Refer to Clutch Pedal Position Sensor Learn .
The Throttle Learn procedure-Refer to Throttle/Idle Learn .
Engine Oil Life Remaining-When available, use a scan tool to rest the Engine Oil Life Remaining back to the original percentage recorded.
Transmission Fluid Life Remaining-When available, use a scan tool to reset the Transmission Fluid Life Remaining back tot he original percentage recorded.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

ECM Replacement

Use the Manual With the Right Hardware

When to See a Mechanic