2011 Chevrolet CapriceFACTORY OEM SERVICE PROCEDURE

Radio Antenna Module Replacement

WARNING: This page is about a different car, the 2010 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Radio Antenna Module
GM2195456Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Lower the rear of the headliner trim panel to access the antenna amplifier. Refer to Headlining Trim Panel Replacement or the sunroof panel trim panel, if equipped. Refer to Sunroof Panel Trim Panel Replacement
1 Radio Antenna Module Bolt
CAUTION: Refer to Fastener Caution .

Tighten:Β  9 N.m (80 lb in)

2 Radio Antenna Module Assembly

Procedure

  1. Disconnect the electrical connection.
  2. Disconnect the antenna cable from the rear glass.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.