Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chevrolet CapriceFACTORY OEM SERVICE PROCEDURE
Circuit/System Verification
- Ignition ON.
- Verify that DTC U0125, U0126, and U0074 are not set.
- If only DTC U0125 is setÂ
Refer to Circuit/System Testing - Only DTC U0125 is set.
- If only DTC U0126 is setÂ
Refer to Circuit/System Testing - Only DTC U0126 is set.
- If DTC U0074 or both DTCs U0125 and U0126 are setÂ
Refer to Circuit/System Testing - DTC U0074.
- If the DTCs listed are not setÂ
- If only DTC U0125 is setÂ
- All OK.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.