2010 Chevrolet Cobalt L4-2.2LFACTORY OEM SERVICE PROCEDURE

Ignition System: Testing and Inspection




Electronic Ignition System Diagnosis

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provide an overview of each diagnostic category.

Circuit/System Description

The ignition system uses individual ignition coil/module assemblies for each cylinder. The engine control module (ECM) controls the individual coils by transmitting timing pulses on the ignition control circuit of each ignition coil/module to enable a spark event.

Diagnostic Aids

* Depending on location in the spliced ignition voltage circuit, a slight resistance can cause a misfire or a crank/no start concern. A voltage drop test will pinpoint this condition.
* A slight to moderate resistance on any ignition control circuit can cause a misfire before DTC P0351-P0354 sets.
* Extended engine cranking time, may foul the spark plugs with excessive fuel.

Reference Information
Schematic Reference

Engine Controls Schematics ([1][2]Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Electrical Information Reference

* Circuit Testing ()
* Connector Repairs ()
* Testing for Intermittent Conditions and Poor Connections ()
* Wiring Repairs ()

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information
Special Tools

J 26792 - HEI Spark Tester

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the affected T8 ignition coil/modules.
2. Ignition OFF, all vehicle systems OFF. This may take up to 2 minutes. Test for less than 5 ohm between the ground circuit terminal A/1 and ground.

• If greater than the specified range, test the ground circuit for an open/high resistance.

3. Test for less than 5 ohm between the low reference circuit terminal B/2 and ground.

• If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K20 ECM.

4. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal D/4 and ground.

• If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.

5. Exchange the affected T8 ignition coil/module with the T8 ignition coil/module of a good cylinder.
6. Start the engine, and observe the scan tool Misfire Current Cylinder parameters.

• If the misfire transfers with the suspect T8 ignition coil/module, replace as needed.

7. If the circuits test normal, test or replace the spark plug/s.

Component Testing

Use the J 26792 - Spark Tester to verify the output of each ignition coil/module.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Ignition Coil Replacement (Service and Repair)
* Spark Plug Replacement (Service and Repair)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.