Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Chevrolet Cobalt L4-2.2LFACTORY OEM SERVICE PROCEDURE
Throttle Position Sensor: Locations
Instrument Panel/Center Console Component Views
Instrument Panel Rear Components
1 - Remote Control Door Lock Receiver (RCDLR) (AUO)
2 - Ambient Light Sensor
3 - Brake Pedal Position (BPP) Sensor
4 - Audio Amplifier (UQ3)
5 - Data Link Connector (DLC)
6 - Clutch Pedal Position (CPP) Sensor (M86 or MU3)
7 - Body Control Module (BCM)
8 - Accelerator Pedal Position (APP) Sensor
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.