2010 Chevrolet Cobalt L4-2.2LFACTORY OEM SERVICE PROCEDURE

Engine Oil: Service and Repair




Engine Oil and Oil Filter Replacement (LAF)

Removal Procedure

Factory service manual diagram



1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Place a drain pan under the oil drain plug.
3. Remove the oil pan drain plug.
4. Allow the oil to drain completely.

Caution: Refer to Fastener Caution (Fastener Caution).

5. Install the oil pan drain plug and tighten to 25 Nm (18 lb ft).
6. Lower the vehicle.

Factory service manual diagram




Note: DO NOT use an open end wrench on the hex on top of the oil filter cap.

7. use an oil filter wrench on the outside diameter of the oil filter cap.
8. Remove the oil filter cap and filter.
9. Remove the filter from the cap.

Installation Procedure

Factory service manual diagram



1. Install the NEW oil filter to the cap.
2. Install the oil filter cap and filter.

Caution: Over torquing the oil filter cap may cause damage to the oil filter cap resulting in an oil leak.

Note: DO NOT use an open end wrench on the hex on top of the oil filter cap.

3. use an oil filter wrench on the outside diameter of the oil filter cap. Tighten the oil filter cap until fully seated. DO NOT exceed 25 Nm (18 lb ft).
4. Fill the engine with oil. Refer to Fluid and Lubricant Recommendations (USA and Canada) (Maintenance).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.