2010 Chevrolet Cobalt L4-2.2LFACTORY OEM SERVICE PROCEDURE

Control Assembly: Locations




Instrument Panel/Center Console Component Views

Instrument Panel Front Components

Factory service manual diagram



1 - Instrument Panel Cluster (IPC)
2 - Ambient Light Sensor
3 - Hazard Warning Switch
4 - Radio
5 - Remote Control Door Lock Receiver (RCDLR) (AUO)
6 - Heated Seat Switch - Passenger (KA1)
7 - HVAC Control Module
8 - Inflatable Restraint Passenger Air Bag On/Off Indicator (AL0 or ASA)
9 - Body Control Module (BCM)
10 - Heated Seat Switch - Driver (KA1)
11 - Traction Control Switch (JL4 of JL9)
12 - I/P Dimmer Switch
13 - Fog Lamp Switch (T37)
14 - Data Link Connector (DLC)
15 - Rear Compartment Lid Release Switch
16 - I/P Trim
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.