Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chevrolet Traverse LS, FWDFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS LOCATION
| Component | Location |
|---|---|
| G101 (4) | Left side of engine compartment, on left frame rail. See Figure. |
| G102 | Right side of engine compartment, on right inner fender panel. See Figure. |
| G103 (3) | Left side of engine compartment, on left inner fender panel. See Figure. |
| G105 (W/Heated Washer Nozzles) | Rear of engine compartment, on left middle of instrument panel bulkhead. See Figure. |
| G110 | Right front of engine, mounted to cylinder head. See Figure. |
| G112 | Rear of engine, mounted to rear of cylinder head. See Figure. |
| G113 (3) | Left side of engine, at engine to transmission stud. See Figure. |
| G114 | Left rear of engine. See Figure. |
| G115 (5) | Left side of engine compartment, on left inner fender panel. See Figure. |
| G300 | Behind right kick panel. See Figure. |
| G301 | Behind left kick panel. See Figure. |
| G302 | Near base of right "B" pillar. See Figure. |
| G303 | Near base of left "B" pillar. See Figure. |
| G304 | Below floor console. See Figure. |
| G305 (2) | Near battery. See Figure. |
| G401 | Near base of left "D" pillar. See Figure. |
| G402 (1) | Above right rear wheelwell. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
