2009 Chevrolet Traverse LS, AWDFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Location
G101 (4) Left side of engine compartment, on left frame rail. See Figure.
G102 Right side of engine compartment, on right inner fender panel. See Figure.
G103 (3) Left side of engine compartment, on left inner fender panel. See Figure.
G105 (W/Heated Washer Nozzles) Rear of engine compartment, on left middle of instrument panel bulkhead. See Figure.
G110 Right front of engine, mounted to cylinder head. See Figure.
G112 Rear of engine, mounted to rear of cylinder head. See Figure.
G113 (3) Left side of engine, at engine to transmission stud. See Figure.
G114 Left rear of engine. See Figure.
G115 (5) Left side of engine compartment, on left inner fender panel. See Figure.
G300 Behind right kick panel. See Figure.
G301 Behind left kick panel. See Figure.
G302 Near base of right "B" pillar. See Figure.
G303 Near base of left "B" pillar. See Figure.
G304 Below floor console. See Figure.
G305 (2) Near battery. See Figure.
G401 Near base of left "D" pillar. See Figure.
G402 (1) Above right rear wheelwell. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.