Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chevrolet Impala V6-3.9LFACTORY OEM SERVICE PROCEDURE
Timing Component Alignment Marks: Locations
- Align the crankshaft timing mark (1) to the timing mark on the bottom of the timing chain tensioner (2).
- Hold the camshaft sprocket with the timing chain hanging down and install the timing chain to the crankshaft gear.
- Align the timing mark on the camshaft gear (4) with the timing mark on top of the timing chain tensioner (3).
- Align the dowel in the camshaft position actuator with the dowel hole in the camshaft.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
