Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chevrolet Corvette V8-6.2L SCFACTORY OEM SERVICE PROCEDURE
Accelerator Pedal Position Sensor: Locations
Instrument Panel/Center Console Component Views
Left Side of Instrument Panel
1 - Brake Pedal Position (BPP) Sensor
2 - Accelerator Pedal Position (APP) Sensor
3 - Sunload Sensor
4 - Windshield Washer/Wiper Switch
5 - Turn Signal/Multifunction Switch
6 - Clutch Pedal Position (CPP) Sensor (MM6/MZ6/MN6)
Under Left Side of the Dash
1 - Stop Lamp Switch X1
2 - Stop Lamp Switch X3
3 - X231
4 - Radio X5 (Denso Radio)
5 - Accelerator Pedal Position (APP) Sensor
6 - Accelerator Pedal
7 - Brake Pedal
8 - Steering Wheel Position Sensor
9 - Clutch Pedal (MM6/MZ6/MN6)
10 - Clutch Pedal Position (CPP) Switch (MM6/MZ6/MN6)
11 - Stop Lamp Switch
12 - Stop Lamp Switch Connector X2
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.