Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chevrolet Corvette V8-6.2L SCFACTORY OEM SERVICE PROCEDURE
Axle Shaft Assembly
Wheel Drive Shafts Disassembled Views
1 - Inner Joint Outer Race
2 - Inner Joint Cage
3 - Inner Joint Inner Race
4 - Ball Bearings
5 - Inner Joint Inner Race Retaining Snap Ring
6 - Inner Joint Outer Race Retaining Ring
7 - Inner Joint Large Seal Clamp
8 - Inner Joint Seal
9 - Inner Joint Small Seal Clamp
10 - Axle Shaft
11 - Outer Joint Small Seal Clamp
12 - Outer Joint Seal
13 - Outer Joint Large Seal Clamp
14 - Ball Bearings
15 - Outer Joint Inner Race
16 - Outer Joint Retaining Ring
17 - Outer Joint Cage
18 - Outer Joint Outer Race
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
