Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chevrolet Corvette V8-6.2L SCFACTORY OEM SERVICE PROCEDURE
Instrument Panel/Center Console Component Views
Instrument Panel/Center Console Component Views
Instrument Panel Harness - Engine Compartment and Lower Right Side of Instrument Panel
1 - Body Control Module (BCM) X2
2 - Fuse Block - I/P
3 - Relay Block - I/P
4 - JX208
5 - Body Control Module (BCM) X1
Right Side of Instrument Panel
1 - JX208
2 - Body Control Module (BCM) X2
3 - Body Control Module (BCM) X3
4 - Body Control Module (BCM) X4
5 - G202
6 - Relay Block - I/P
7 - G302
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.