Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chevrolet Corvette V8-6.2L SCFACTORY OEM SERVICE PROCEDURE
Harness Routing Views
Harness Routing Views
Instrument Panel Splice Locations - Console, Lower Right and Overhead
1 - J351
2 - J640
3 - J213 (CM7)
4 - J312
5 - J234
6 - Body Control Module (BCM) X3
7 - J208
8 - J222
9 - Fuse Block - Instrument Panel
10 - J246
11 - J255
12 - J205
13 - J204
14 - J219 (CO5/CM7 and UZD)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.