Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chevrolet Uplander V6-3.9LFACTORY OEM SERVICE PROCEDURE
HVAC Control Module Programming and Setup
HVAC Control Module Programming and Setup
Each of the following service procedures requires programming or setup procedures to be performed on the HVAC control module.
HVAC Control Module Replacement
If the HVAC control module is replaced, the following procedure must be performed:
Re-Calibrating Actuators-Refer to Actuator Recalibration (Programming and Relearning).
Actuator Replacement
If an actuator is replaced, the following procedure must be performed:
Re-Calibrating Actuators-Refer to Actuator Recalibration (Programming and Relearning).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.