Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chevrolet Uplander V6-3.9LFACTORY OEM SERVICE PROCEDURE
Memory Positioning Module: Locations
Passenger Compartment/Roof Component Views
Driver Seat Components
1 - Seat Belt Switch - Left
2 - Seat Back Cover
3 - Heated Seat Element - Driver Back (KA1)
4 - Inflatable Restraint Side Impact Module - Left (AJ7/AW9), Inflatable Restraint Side Impact Module - Left Rear (AW9) Similar
5 - Memory Seat Module - Driver (AG0)
6 - Seat Adjuster Motor Assembly - Driver (AG0/AG1)
7 - Seat Adjuster Switch - Driver (AG0/AG1)
8 - Heated Seat Element - Driver Cushion (KA1)
9 - Seat Cushion Cover
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.