SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR SS, AUTOMATICREPAIR AND DIAGNOSISSTEERINGPOWER STEERING SYSTEMREPAIR INSTRUCTIONSELECTRONIC POWER STEERING MOTOR CONTROL MODULE REPLACEMENT (SS)INSTALLATION PROCEDURE
2008 Chevrolet HHR SS, Automatic

Installation Procedure

2008 Chevrolet HHR SS, AutomaticSECTION Installation Procedure
    Fig 1: Identifying Electronic Power Steering Motor Control Module Bracket And Bolts
    GM2035154Courtesy of GENERAL MOTORS CORP.
  1. Position the electronic power steering motor control module and bracket (2) together.
    2. NOTE: Refer to Fastener Notice .
  2. Install the electronic power steering motor control module bolts (1).

    Tighten:  Tighten the bolts to 11.5 N.m (102 lb in).

    3. Fig 2: Electronic Power Steering Motor Control Module Bracket Bolts
    GM2035067Courtesy of GENERAL MOTORS CORP.
  3. Install the electronic power steering motor control module and bracket to the vehicle.
  4. Install the electronic power steering motor control module bracket bolts (1).

    Tighten:  Tighten the bolts to 11.5 N.m (102 lb in).

  5. Connect the electronic power steering motor control module electrical connectors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.