Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chevrolet Corvette Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications
| Front Suspension Wheel Alignment | ||||||||
|---|---|---|---|---|---|---|---|---|
| Service at Curb | ||||||||
| Suspension | Caster ± 0.60 Degrees |
Cross Caster Left - Right ± 0.60 Degrees |
Camber ± 0.60 Degrees |
Cross Camber Left - Right ± 0.60 Degrees |
Total Toe Left + Right ± 0.20 Degrees |
Steering Wheel Angle ± 3.5 Degrees |
||
| L | R | L | R | |||||
| FE1, FE2, FE3 | 7.50° | 7.50° | 0.0° | -0.45° | -0.45° | 0.0° | 0.10° | 0.0° |
| FE4 | 7.60° | 7.60° | 0.0° | -1.00° | -1.00° | 0.0° | 0.10° | 0.0° |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.