Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Install the radio mounting bracket. Perform the following steps:
- Attach the HVAC harness to the radio mounting bracket with the clip.
- Install the screws (2) in order to retain the radio mounting bracket (1) to the instrument panel carrier.
Tighten: Tighten the screws to 3 N.m (27 lb in).
NOTE: Refer to Fastener Notice . - Connect the electrical/audio and antenna cable connectors to the radio.
- Install the radio to the support bracket (1).
- Align the radio locator tab into the support bracket locator hole.
- Install the radio screws (2).
Tighten: Tighten the screws to 2 N.m (18 lb in).
- Install the instrument cluster panel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
- Calibrate the new radio assembly. Refer to Control Module References .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.