2008 Chevrolet Aveo BaseFACTORY OEM SERVICE PROCEDURE

Shift Lock Control Connector End Views (Notchback)

WARNING: This page is about a different variant/trim than selected.
Automatic Transmission Shift Lever

GM1467039Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • MG610396
  • 4-Way F Series Sealed (WH)
Pin Wire Color Circuit No. Function
1 OG/BK 434 Automatic Transmission Shift Lock Control (w/o NNK)
BN 1075 Park Position Switch Signal (NNK)
2 BK 650 Ground
3 OG/BK 434 Automatic Transmission Shift Lock Control
4 PK 239 Ignition 1 Voltage (NNK)
PU 878 Stop Lamp Switch Signal (w/o NNK)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.