Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chevrolet Aveo BaseFACTORY OEM SERVICE PROCEDURE
Remote Function Connector End Views (Notchback)
Remote Control Door Lock Receiver (RCDLR)/Theft Deterent Control Module
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| 1 | YE | - | Arm Alarm Signal |
| 2 | BK | - | Ground |
| 3 | - | - | Not Used |
| 4 | PU | - | Rear Compartment Lid Switch Signal |
| 5 | OG/BK | - | Rear Compartment Lid Ajar Switch Signal |
| 6 | - | - | Not Used |
| 7 | PK/D-BU | - | Hood Ajar Switch Signal |
| 8 | WH | - | Door Ajar Signal |
| 9 | L-BU | - | Door Lock Control |
| 10 | GY/D-GN | - | Driver Door Lock Relay Lock Control |
| 11 | YE | - | Driver Door Lock Relay Unlock Control |
| 12 | PU | - | Door Latch Switch Signal |
| 13 | D-BU | - | Right Turn Signal Lamps Supply Voltage |
| 14 | BN | - | Rear Compartment Lid Switch Signal |
| 15 | PK | - | Ignition 1 Voltage |
| 16 | - | - | Not Used |
| 17 | BK/WH | - | Serial Data |
| 18 | L-GN | - | Key In Ignition Switch Signal |
| 19 | YE | - | Security Indicator Control |
| 20 | PU | - | Door Latch Switch Signal |
| 21-24 | - | - | Not Used |
| 25 | RD/WH | - | Battery Positive Voltage |
| 26 | L-BU | - | Left Turn Signal Lamps Supply Voltage |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
