Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet Uplander V6-3.9LFACTORY OEM SERVICE PROCEDURE
Ignition Lock: Service and Repair
Ignition Lock Cylinder Replacement
Removal Procedure
1. Disconnect the battery negative cable.
Caution: refer to SIR Caution.
2. Disable the SIR system.
3. Remove the steering wheel.
4. Remove the retaining screw from the lower steering column trim covers.
5. Tilt the trim cover down and slide rearward in order to disengage the locking tabs. Remove the lower steering column trim covers.
6. Remove the retaining screws from the upper steering column trim cover.
7. Lift the trim cover in order to gain access to the lock cylinder access hole (1).
8. Insert the Snap-On A173A bent-tip awl (1) or equivalent, with a 2.5 mm (3/32 in) tip, and 20 mm (3/4 in) in length, into the access hole of the ignition lock cylinder.
9. Turn the ignition lock cylinder to START.
10. Use the bent tip in order to push down on the ignition lock cylinder retainer.
11. Release the ignition lock cylinder to the RUN position.
12. Remove the ignition lock cylinder from the lock cylinder case.
Installation Procedure
1. Insert the ignition lock cylinder through the trim cover in the upper steering column.
2. Align the lock cylinder retaining tab and the position tab with the slots in the lock housing.
3. Completely push the lock cylinder into the lock housing.
Notice: refer to Fastener Notice.
4. Install the retaining screws to the upper steering trim cover.
Tighten the screws to 3.5 N.m (31 lb in).
5. Match the tab slots on the lower trim cover with the locking tabs on the upper trim cover.
6. Tilt the lower trim cover up and slide the lower trim cover until the locking tabs snap into the tab slots.
7. Install the lower trim cover screws to the steering column.
Tighten the screws to 1.5 N.m (13 lb in).
8. Install the steering wheel.
9. Enable the SIR system. refer to SIR Disabling and Enabling.
10. Connect the battery negative cable. refer to Battery Negative Cable Disconnection and Connection.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
