Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet Uplander V6-3.9LFACTORY OEM SERVICE PROCEDURE
Cruise Control: Locations
Cruise Control Component Views
Steering Wheel Components
1 - Horn Switch Connector
2 - Cruise Control Lever Connector (K34)
3 - Steering Wheel Control Switch Assembly - Right (UK3)
4 - Cruise Control Lever (K34)
5 - S293 (UK3)
6 - S297 (UK3)
7 - Steering Wheel Ground
8 - C279 Inflatable Restraint Steering Wheel Module Coil to Steering Wheel Harness
9 - S295 (UK3)
10 - Steering Wheel Control Switch Assembly - Left (UK3)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
