Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet Uplander V6-3.9LFACTORY OEM SERVICE PROCEDURE
Cruise Control Switch: Service and Repair
Cruise Control Switch Replacement
Removal Procedure
1. Remove the steering wheel from the vehicle.
2. Remove the steering wheel electrical harness grounding screw (1).
3. Release the electrical harness connector retainer clip (2) from the steering wheel trim cover.
4. Remove the steering wheel rear trim cover screws (4).
5. Remove the cruise control switch screws (2).
6. Remove the steering wheel trim cover (3).
7. Remove the cruise control switch (1).
Installation Procedure
1. Install the cruise control switch (1).
2. Install the steering wheel trim cover (3).
Notice: Refer to Fastener Notice.
3. Install the cruise control switch screws (2).
Tighten the screws to 6 N.m (53 lb in).
4. Install the steering wheel rear trim cover screws (4).
Tighten the screws to 6 N.m (53 lb in).
5. Install the steering wheel electrical harness grounding screw (1).
Tighten the screw to 6 N.m (53 lb in).
6. Attach the electrical harness connector retainer clip (2) to the steering wheel trim cover.
7. Install the steering wheel to the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.