Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet Uplander V6-3.9LFACTORY OEM SERVICE PROCEDURE
Keyless Entry Module: Service and Repair
Remote Control Door Lock Receiver Replacement
Removal Procedure
1. Remove the instrument panel (I/P) upper trim.
2. Disengage the retaining tabs in order to remove the door lock receiver from the I/P upper trim.
3. Disconnect the electrical connector from the door lock receiver.
Installation Procedure
1. Connect the electrical connector to the door lock receiver.
2. Engage the retaining tabs in order to install the door lock receiver to the I/P upper trim.
3. Install the I/P upper trim.
4. Program transmitter to the new receiver.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.