Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet Optra5 LS, AutomaticFACTORY OEM SERVICE PROCEDURE
Component Testing
- Ignition OFF, disconnect the harness connector of the CKP sensor.
- Connect a DMM between the signal circuit and the low reference circuit of the CKP sensor.
- Test for 460-620 ohms between the signal circuit and low reference circuit.
- If the resistance is not within the specified range, replace the CKP sensor.
- Disconnect the fuel pump relay.
- Set the DMM to the AC voltage scale.
- While cranking the engine, test for more than 1.4 ACV between the signal circuit and low reference circuit of the CKP sensor.
- If less than 1.4 ACV, replace the CKP sensor.
IMPORTANT:
If the CKP sensor lead is damaged in any way, replace the CKP sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.