2007 Chevrolet Optra (CANADA) L4-2.0LFACTORY OEM SERVICE PROCEDURE

Audible Warning Device Control Module: Service and Repair




Audio Alarm Module Replacement

Removal Procedure

Factory service manual diagram




Caution: Refer to Battery Disconnect Caution Battery Disconnect Caution.

1. Disconnect the negative battery cable.
2. Remove the knee bolster trim panel beneath the steering column.
3. Disconnect the electrical connector.
4. Remove the screws and the chime module.

Installation Procedure

Factory service manual diagram




Notice: Refer to Fastener Notice Fastener Notice.

1. Install the chime module with the screws.
2. Connect the electrical connector.
3. Install the knee bolster trim panel beneath the steering column.
4. Connect the negative battery cable.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.