2007 Chevrolet Malibu L4-2.2LFACTORY OEM SERVICE PROCEDURE

Seat Temperature Control Module: Service and Repair



Heated Seat Control Module Replacement - Front

Removal Procedure

Caution: Refer to SIR Caution.

1. Remove the front seat.

Factory service manual diagram



2. Disconnect the electrical connection from the heated seat control module.

Factory service manual diagram



3. Remove the fastener from the heated seat control module.

Factory service manual diagram



4. Remove the heated seat control module.

Installation Procedure

Factory service manual diagram



1. Install the heated seat control module.

Factory service manual diagram



2. Install the fastener to the heated seat control module.

Factory service manual diagram



3. Connect the electrical connection to the heated seat control module.
4. Install the front seat.
5. Verify that the heated seat works correctly.
6. Refer to Control Module References for programming and setup information. Programming and Relearning
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.