2007 Chevrolet Impala V8-5.3LFACTORY OEM SERVICE PROCEDURE

Oil Pressure Sensor: Service and Repair



Engine Oil Pressure Sensor and/or Switch Replacement

Tools Required

J 41712 Oil Pressure Sensor Socket

Removal Procedure

Factory service manual diagram



1. If necessary, remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement.
2. Disconnect the oil pressure sensor electrical connector (4).

Factory service manual diagram



3. Using J 41712, remove the oil pressure sensor (706) and washer (707).

Installation Procedure

Factory service manual diagram



1. Apply sealant to the threads of the oil pressure sensor. Refer to Sealers, Adhesives, and Lubricants for the 3.9L engine.

Notice: Refer to Fastener Notice.

2. Using J 41712, install the oil pressure sensor (706) and washer (707).

Tighten the sensor to 35 N.m (26 lb ft).

Factory service manual diagram



3. Connect the oil pressure sensor electrical connector (4).
4. If necessary, install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.