2007 Chevrolet Impala V6-3.9LFACTORY OEM SERVICE PROCEDURE

Oil Pressure Sensor: Service and Repair



Engine Oil Pressure Sensor and/or Switch Replacement

Removal Procedure

Factory service manual diagram



1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the oil pressure sensor heat shield nut and shield.

Factory service manual diagram



3. Disconnect the engine oil pressure sensor electrical connector (1).

Factory service manual diagram



4. Remove the engine oil pressure sensor.

Installation Procedure

Factory service manual diagram




Notice: Refer to Fastener Notice.

1. Install the engine oil pressure sensor.

Tighten the sensor to 16 N.m (12 lb ft).

Factory service manual diagram



2. Connect the engine oil pressure sensor electrical connector (1).

Factory service manual diagram



3. Install the oil pressure sensor heat shield and nut.

Tighten the nut to 10 N.m (89 lb in).

4. Lower the vehicle.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.