2007 Chevrolet Impala V6-3.9LFACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor: Service and Repair



Crankshaft Position Sensor Replacement

Removal Procedure

Factory service manual diagram



1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the crankshaft position (CKP) sensor electrical connector (4).

Factory service manual diagram



3. Remove the CKP sensor stud.
4. Remove the CKP sensor.

Installation Procedure

Factory service manual diagram



1. Lubricate the CKP sensor O-ring with clean engine oil.
2. Install the CKP sensor.
3. Install the CKP sensor stud.

Tighten the stud to 10 N.m (89 lb in).

Factory service manual diagram



4. Connect the CKP sensor electrical connector (4).
5. Lower the vehicle.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.