Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet Impala SSFACTORY OEM SERVICE PROCEDURE
Turn Signal/Multifunction Switch C2
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Lighting Systems Connector End Views
Connector Part Information
|
Terminal Part Information
|
Turn Signal/Multifunction Switch C2
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| A | BN | 1356 | Flash To Pass Switch Signal |
| B-C | - | - | Not Used |
| D | BK/WH | 1551 | Ground |
| E | PU | 524 | Headlamp Dimmer Switch High Beam Signal |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.