Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet Impala SSFACTORY OEM SERVICE PROCEDURE
Section 187 (Programming And Setup - All Systems)
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Repair Instructions
- AC/DC Power Outlet Control Module Programming and Setup
- Actuator Control Module - Power Sliding Door (PSD) Programming and Setup
- Service Programming System (SPS)
- Automatic Level Control Sensor Programming and Setup
- Body Control Module Programming and Setup
- Communication Interface Module (OnStar) Programming and Setup
- Digital Radio Receiver Programming and Setup
- Electronic Brake Control Module Programming and Setup
- Engine Control Module - 3.9L Engine
- Garage Door Opener Programming and Setup
- HVAC Control Module Programming and Setup
- Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
- Instrument Panel Cluster Programming and Setup
- Passenger Presence System Programming and Setup
- Engine Control Module - 3.5L Engine
- Radio Programming and Setup
- Transmission Control Module Programming and Setup
- Object Alarm Module Programming and Setup
- Remote Control Door Lock Receiver Programming and Setup
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
