2007 Chevrolet HHR LS, StandardFACTORY OEM SERVICE PROCEDURE

Remote Control Door Lock Receiver Replacement

Fig 1: Remote Control Door Lock Receiver Replacement
GM1614240Courtesy of GENERAL MOTORS CORP.
Remote Control Door Lock Receiver Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the rear seat. Refer to Rear Seat Replacement .
  2. Remove the left rear quarter lower trim panel. Refer to Rear Quarter Lower Trim Panel Replacement .
1 Module, Remote Control Door Lock
Tip: 
  1. The module is secured to the seat back cushion latch bracket with three integral tabs, pull away from the bracket to remove.
  2. Disconnect the electrical connector.
  3. Reprogram the remote control door lock module after installation. Refer to Control Module References .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.