Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet HHR LS, AutomaticFACTORY OEM SERVICE PROCEDURE
Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location |
|---|---|
| BCM Fuseholder | In rear of vehicle compartment, near battery. See Figure. |
| Fuse Block - Rear Access Panel (Panel Van) | Right rear of cargo area. See Figure. |
| Fuse Block - Underhood | In engine compartment, next to left strut tower. See Figure. |
| Liftgate Relay Block (Panel Van) | In engine compartment, attached to left wheel well. See Figure. |
| VCIM Fuseholder | In rear compartment of vehicle, near battery. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.