Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet HHR L4-2.2LFACTORY OEM SERVICE PROCEDURE
Ignition Coil: Service and Repair
Ignition Coil Replacement
Removal Procedure
1. Ensure that the ignition key is in the OFF position.
2. Remove the air cleaner assembly.
3. Disconnect the ignition coil electrical connector(s) (1).
4. Remove the ignition coil bolt(s).
5. Remove the ignition coil(s).
Installation Procedure
1. Install the ignition coil(s).
Notice: Refer to Fastener Notice.
2. Install the ignition coil bolt(s).
Tighten the bolt(s) to 10 N.m (89 lb in).
3. Connect the ignition coil electrical connector(s) (1).
4. Install the air cleaner assembly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
