Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet Express 3500 V8-4.8LFACTORY OEM SERVICE PROCEDURE
Fastener Tightening Specifications
Connecting Rod Bolts
First Pass 20 N.m (15 lb ft)
Final Pass 70 degrees
Crankshaft Balancer Bolt - Installation Pass - to Ensure the Balancer is Completely Installed 330 N.m (240 lb ft)
Crankshaft Balancer Bolt - First Pass - Install a NEW Bolt After the Installation Pass and Tighten as Described in the First and Final Passes 50 N.m (37 lb ft)
Crankshaft Balancer Bolt - Final Pass 140 degrees

Crankshaft Bearing Cap M8 Bolts 25 N.m (18 lb ft)
Crankshaft Bearing Cap M10 Bolts
First Pass in Sequence 20 N.m (15 lb ft)
Final Pass in Sequence 80 degrees
Crankshaft Bearing Cap M10 Studs
First Pass in Sequence 20 N.m (15 lb ft)
Final Pass in Sequence 51 degrees
Crankshaft Oil Deflector Nuts 25 N.m (18 lb ft)
Crankshaft Position (CKP) Sensor Bolt 25 N.m (18 lb ft)
Crankshaft Rear Oil Seal Housing Bolts 30 N.m (22 lb ft)
First Pass 20 N.m (15 lb ft)
Final Pass 70 degrees
Crankshaft Balancer Bolt - Installation Pass - to Ensure the Balancer is Completely Installed 330 N.m (240 lb ft)
Crankshaft Balancer Bolt - First Pass - Install a NEW Bolt After the Installation Pass and Tighten as Described in the First and Final Passes 50 N.m (37 lb ft)
Crankshaft Balancer Bolt - Final Pass 140 degrees
Crankshaft Bearing Cap M8 Bolts 25 N.m (18 lb ft)
Crankshaft Bearing Cap M10 Bolts
First Pass in Sequence 20 N.m (15 lb ft)
Final Pass in Sequence 80 degrees
Crankshaft Bearing Cap M10 Studs
First Pass in Sequence 20 N.m (15 lb ft)
Final Pass in Sequence 51 degrees
Crankshaft Oil Deflector Nuts 25 N.m (18 lb ft)
Crankshaft Position (CKP) Sensor Bolt 25 N.m (18 lb ft)
Crankshaft Rear Oil Seal Housing Bolts 30 N.m (22 lb ft)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
