Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet Express 3500 V8-4.8LFACTORY OEM SERVICE PROCEDURE
Axle Shaft Assembly
Wheel Drive Shafts Disassembled Views
Halfshaft Disassembled View
Halfshaft Disassembled View:
1 - Retaining Ring
2 - Large Seal Retaining Clamp
3 - CV Joint Seal
4 - Wheel Drive Shaft Bar
5 - Small Seal Retaining Clamp
6 - Large Seal Retaining Clamp
7 - Ball
8 - CV Joint Inner Race
9 - CV Joint Outer Race
10 - CV Joint Cage
11 - Retaining Ring
12 - CV Joint Seal
13 - Small Seal Retaining Clamp
14 - Tripot Bushing
15 - Tripot Joint Spider Assembly
16 - Tripot Housing Assembly
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
