2007 Chevrolet Express 2500 V8-4.8LFACTORY OEM SERVICE PROCEDURE

Oil Pressure Sensor: Service and Repair



Engine Oil Pressure Sensor and/or Switch Replacement

Tools Required

J 41712 Oil Pressure Sensor Socket

Removal Procedure

1. Remove the engine cover.

Factory service manual diagram



2. Disconnect the oil pressure sensor electrical connector (1).

Factory service manual diagram



3. Using J 41712 or equivalent, remove the oil pressure sensor.

Installation Procedure

Factory service manual diagram



1. Apply sealant to the threads of the oil pressure sensor. Refer to Sealers, Adhesives, and Lubricants for the correct part number.

Notice: Refer to Fastener Notice.

2. Using J 41712 or equivalent, install the oil pressure sensor.

Tighten the oil pressure sensor to 35 N.m (26 lb ft).

Factory service manual diagram



3. Connect the oil pressure sensor electrical connector (1).
4. Install the engine cover.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.