Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet Express 2500 V8-4.8LFACTORY OEM SERVICE PROCEDURE
Cruise Control: Locations
Cruise Control Component Views
LR of the Engine Compartment (4.3L)
1 - Windshield Wiper Motor
2 - Cruise Control Module (CCM)
LR of the Engine Compartment (4.8L/5.3L/6.0L)
1 - Throttle Actuator Control (TAC) Module
Upper Steering Column
1 - Cruise Control Set Switch (K34)
2 - Windshield Washer Switch
3 - Hazard Switch
4 - Steering Wheel
5 - Windshield Wiper Switch
6 - Cruise Control ON/OFF/RESUME Switch (K34)
7 - Steering Column
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
