2007 Chevrolet Express 1500 RWD V8-5.3LFACTORY OEM SERVICE PROCEDURE

Glow Plug Control Module Programming and Setup



Glow Plug Control Module Programming and Setup

The following service procedures require either a programming or a setup event performed for a complete repair.

GPCM Replacement

If the glow plug controller (GPCM) is replaced, the following procedures must be performed.

* Fuel Injector Flow Rate Programming for fuel injector flow rate programming
* Service Programming System (SPS) for GPCM programming

GPCM Reprogramming

If the glow plug controller (GPCM) needs to be reprogrammed, refer to Service Programming System (SPS). Programming and Relearning

Setup for Component Replacement

The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, the Fuel Injector Flow Rate Programming must be performed. Refer to Fuel Injector Flow Rate Programming.

* Fuel injector
* Engine control module (ECM)
* GPCM
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.