2007 Chevrolet Cobalt L4-2.4LFACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor: Service and Repair



Crankshaft Position Sensor Replacement

Removal Procedure

Factory service manual diagram



1. Remove the starter.
2. Disconnect the crankshaft position (CKP) sensor wiring harness electrical connector from the CKP sensor.

Factory service manual diagram



3. Remove the CKP sensor bolt.
4. Remove the CKP sensor.

Installation Procedure

Factory service manual diagram



1. Lubricate the CKP sensor O-ring seal with clean engine oil.
2. Install the CKP sensor.

Notice: Refer to Fastener Notice.

3. Install the CKP sensor bolt.

Tighten the bolt to 10 N.m (89 lb in).

Factory service manual diagram



4. Connect the CKP sensor wiring harness electrical connector to the CKP sensor.
5. Install the starter.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.