Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chevrolet Cobalt L4-2.0L SCFACTORY OEM SERVICE PROCEDURE
Air Flow Meter/Sensor: Service and Repair
Mass Airflow Sensor Replacement
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the left front tire and wheel.
3. Remove the left front fender liner..
4. Remove the left front splash shield-engine.
5. Disconnect the electrical connector from the mass air flow (MAF) sensor.
6. Remove the 2 fasteners.
7. Remove the MAF sensor from the air cleaner housing.
Installation Procedure
1. Install the MAF sensor into the air cleaner housing.
Notice: Refer to Fastener Notice.
2. Secure the MAF sensor to the air cleaner housing with the 2 fasteners.
Tighten the 2 fasteners to 2 N.m (18 lb in).
3. Connect the MAF sensor electrical connector.
4. Install the left front splash shield-engine.
5. Install the left front fender liner.
6. Install the left front tire and wheel.
7. Lower the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.