2007 Chevrolet Cobalt L4-2.0L SCFACTORY OEM SERVICE PROCEDURE

Engine Oil: Service and Repair



Engine Oil and Oil Filter Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Place a drain pan under the oil drain plug.

Factory service manual diagram



3. Remove the oil pan drain plug.
4. Lower the vehicle.

Important: DO NOT use an open end wrench on the hex on top of the oil filter cap.

5. Without supercharger - use a 32 mm socket with a long extension (1/2 to 3/8 reducer helps if available) and ratchet on the hex on the top of the oil filter cap.
6. With Supercharger - the oil filter is accessible by reaching under the supercharger. Use a 32 mm socket with the needed flex handle or box wrench.
7. Loosen the oil filter housing.
8. Remove the tools.

Factory service manual diagram



9. Remove the oil filter and housing.
10. Remove the filter from the cap.

Installation Procedure

Factory service manual diagram



1. Install the filter to the housing.
2. Install the oil filter cap with filter.
3. Install the oil filter to the housing.

Notice: Over torquing the oil filter cap may cause damage to the oil filter cap resulting in an oil leak.

Notice: Refer to Fastener Notice.

Important: DO NOT use an open end wrench on the hex on top of the oil filter cap.

4. Use a 32 mm socket with a long extension (1/2 to 3/8 reducer helps if available) and ratchet on the hex on the top of the oil filter cap.

Tighten the oil filter cap until fully seated, DO NOT exceed 25 N.m (18 lb ft).

5. Raise the vehicle.

Factory service manual diagram



6. Install the oil pan drain plug.

Tighten the oil pan drain plug to 25 N.m (18 lb ft).

7. Lower the vehicle.
8. Fill the engine with oil. Refer to Fluid and Lubricant Recommendations.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.