Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chevrolet Uplander BaseFACTORY OEM SERVICE PROCEDURE
Body Control Module (BCM) Replacement
WARNING: This page is about a different car, the 2006 Chevrolet Monte Carlo and 2006 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
The vehicle will not start and many other functions may not operate properly if a replacement body control module (BCM) is not properly set up. The following procedures must be performed in the following order:
- BCM Reprogramming-Refer to Body Control Module (BCM) Programming/RPO Configuration .
- Learning the restraints ID-Refer to Body Control Module (BCM) Programming/RPO Configuration .
- BPP Sensor calibration-Refer to Body Control Module (BCM) Programming/RPO Configuration .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.