2006 Chevrolet SSR StandardFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Yaw Rate Sensor & Nuts
    GM1236994Courtesy of GENERAL MOTORS CORP.
  1. Position the yaw rate sensor in the vehicle (1).
  2. NOTE: Refer to Fastener Notice .
  3. Install the yaw rate sensor bolts (2).

    Tighten:Β  Tighten the bolts to 7 N.m (62 lb in).

  4. Connect the yaw rate sensor electrical connector.
  5. Install the HVAC Control Module. Refer to HVAC Control Module Replacement .
  6. Install the IP accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
  7. Turn the ignition switch to the ON position, engine off.
  8. Perform the Diagnostic System Check - Vehicle .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.