2006 Chevrolet SSR StandardFACTORY OEM SERVICE PROCEDURE

Traction Control Switch Replacement

WARNING: This page is about a different car, the 2007 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Traction Control Switch Assembly
GM1765026Courtesy of GENERAL MOTORS CORP.
Traction Control Switch Replacement

Callout Component Name
Preliminary Procedure:Β 
Remove the Instrument Panel Accessory Trim Plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
1 Traction Control Switch Assembly
Tip:Β  Squeeze the tabs securing the traction control switch to the trim plate and remove the switch from the plate.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.